What Is The Best Way To Clean A Rug in Whittier

What’s The Best Way To Clean A Rug?

Area rugs are a great way to add warmth and personality to your decor, but after prolonged use, they will require a good cleaning to seem like new. For many modern rugs, cleaning may be a once-a-year DIY project which saves you the cost of specialist cleaning. If your rug is labeled with specific cleaning instructions, follow these. Otherwise, use this guide from Green Carpet’s Rug Cleaning to understand how to clean a rug along with basic rug maintenance tips.

Generally, area rugs only need to be deep cleaned yearly. Here are a Couple of ways to determine if it is time for Rug Cleaning in Whittier:

1. Lift a corner of the rug and lightly kick the back. If the rug releases a large cloud of dust, it definitely needs some attention.

2. Run your hand against the rug face in a circular motion for 10 seconds, then look at your palm; if your hand is dirty, then so is the rug.

3. Check for signs of deeply embedded dirt by looking at the rug backing. Deep-down dirt will settle along the warp and weft of the rug and can be seen in the backing.

Cleaning a rug just requires a few basic tools. You may need:

Rug beater or broom
Rug shampoo or safe cleaning solution
Two 5 gallon buckets
Large sponges
Towels
Large tarp
Fan

Try to pick a time to clean your rugs if there is going to be a few glowing, hot days together. It could be easier to clean your rugs outside, and sun and warm atmosphere will help them dry faster and thoroughly. Additionally, the sunlight is a natural and effective deodorizer and this will keep the majority of the dirt and dust from the house. If an outside area isn’t available, use any floor area that moisture will not damage (like concrete or vinyl floor in the kitchen or garage.)

Shake or beat: Take smaller rugs and medium-sized rugs outside and provide them a fantastic shake to release loose dust and dirt. If the rug is large, request a spouse for help to hang the rug above a porch rail or above a couple of solid chairs. Don’t forget to shake out the rug mat also.

Fill another bucket with clean water.

Test the rug for colorfastness: Before cleaning a rug with any type of solution, it needs to be tested for colorfastness to prevent damage. Dab the cleaning solution on a small corner of the rug with a white towel. Check to see whether any color transfers to the towel. Let the test place dry thoroughly, then check again to make sure colours have not bled or faded.

Scrub, if needed: When the rug is colorfast, apply the soap solution to the rug using a soft-bristle brush or sponge. Start at one end of this rug. Dip the sponge/brush into the cleaning solution. Do not over-wet the fibers–just use as much as required. Work in a 3- from 3-foot area. Rinse the sponge/brush frequently so the dirt won’t be transferred.

Scrub the rug completely: It’s important not to leave any soap material on the rug. Dip a clean sponge at the rinse water and then remove any soap in the area just cleaned.

Blot: Drive as much excess water as you can with a squeegee and moving in the direction of this rug nap. Utilize the towels to absorb any excess moisture. Scrub, rinse and blot an area before going into the next.

Dry: Hang up the rug to dry, or lay the rug flat, face-up and prop the underside with risers to permit for air circulation. Allow the rug dry thoroughly before bringing it back indoors, rotating it periodically to promote even drying. Once inside, turn on fans to encourage greater air circulation and assist the rug dry more completely.

Adjust rug fibers: When the rug has dried thoroughly, lightly examine the rug using a vacuum or a soft-bristle brush to Blend the fibers.

Steam cleaners: If your rug is very soiled, it may be worth it to rent a commercial steam cleaner. Vacuum the rug first, then follow the manufacturer’s instructions on how best to run the machine.