Area rugs are a excellent way to add warmth and character to your decoration, but after prolonged use, they will need a good cleaning to look like brand new. For most contemporary rugs, cleaning may be a once-a-year DIY job which saves you the cost of specialist cleaning. If your rug is labeled with specific cleaning instructions, follow those.

In general, area rugs only need to be deep cleaned yearly. Here are a few ways to Find out If It’s time for Rug Cleaning in Sunland:

1. Lift a corner of the rug and lightly kick the back. If the rug releases a large cloud of dust, it definitely needs some attention.

2. Run your hand against the rug face in a circular motion for 10 seconds, then look at your palm; if your hand is dirty, then so is the rug.

3. Check for signs of deeply embedded dirt by looking at the rug backing. Deep-down dirt will settle along the warp and weft of the rug and can be seen in the backing.

Cleaning a rug only requires a few basic tools. You may need:

Rug beater or broom
Rug shampoo or safe cleaning solution
Two 5 gallon buckets
Large sponges
Towels
Large tarp
Fan

Try to pick a time to clean your rugs if there is going to be a few sunny, hot days together. It could be a lot easier to clean your rugs outdoors, and sun and warm atmosphere will help them dry more quickly and thoroughly. Additionally, the sun is a natural and effective deodorizer and this will keep most of the dirt and dust out of the home. Whether an outside area is not available, use any floor area that moisture will not damage (like concrete or vinyl floor in the kitchen or garage.)

Shake or beat: Require smaller rugs and darkened rugs outdoors and give them a fantastic shake to release loose dust and dirt. If the rug is large, request a partner for help to hang the rug over a porch railing or above a couple of solid chairs. Use a broom or rug beater to reach the rug around to loosen deeply embedded dirt. Don’t forget to shake out the rug pad too.

Fill the other bucket with clean water.

Examine the rug for colorfastness: Prior to cleaning a rug with any type of solution, it needs to be examined for colorfastness to avoid damage. Dab the cleaning solution on a tiny corner of this rug with a white towel. Check to find out whether any color transfers to the towel. Allow the test spot dry thoroughly, then check again to make certain colors haven’t bled or faded.

Dip the sponge/brush to the cleaning solution. Don’t over-wet the fibers–just use as much as required. Use gentle pressure to lightly scrub the rug. Function in a 3- by 3-foot area. Rinse out the sponge/brush frequently so the dirt won’t be transferred.

Scrub the rug completely: It’s important not to leave any soap material on the rug. Soap will attract more dirt. Dip a clean sponge at the rinse water and then remove any soap in the region just cleaned.

Blot: Push out as much excess water as possible using a squeegee and moving in the direction of the rug nap. Use the towels to absorb any excess moisture. Scrub, rinse and blot an area before moving to the next.

Allow the rug dry thoroughly before bringing it back indoors, rotating it occasionally to promote even drying. Once inside, turn on fans to encourage more air flow and assist the rug dry completely.

Adjust rug fibers: When the rug has dried thoroughly, lightly go over the rug with a vacuum or a soft-bristle brush to refresh the fibers.

Steam cleaners: If your rug is very soiled, it could be worth it to let a commercial steam cleaner. Vacuum the rug first, then follow the manufacturer’s instructions about how best to operate the machine.

Check related blogs about Rug Cleaning:
How Often Should I Clean My Rugs in Sunland