What Is The Best Way To Clean A Rug in Lakewood

What Is The Best Way To Clean A Rug?

Area rugs are a great way to add warmth and character to your decor, but after prolonged use, they will need a good cleaning to seem like brand new. For most modern rugs, cleaning can be a once-a-year DIY job that saves you the expense of specialist cleaning. If your rug is labeled with particular cleaning instructions, follow these.

Generally, area rugs just have to be deep cleaned annually. Listed below are a Couple of ways to Find out If It’s time for Rug Cleaning in Lakewood:

1. Lift a corner of the rug and lightly kick the back. If the rug releases a large cloud of dust, it definitely needs some attention.

2. Run your hand against the rug face in a circular motion for 10 seconds, then look at your palm; if your hand is dirty, then so is the rug.

3. Check for signs of deeply embedded dirt by looking at the rug backing. Deep-down dirt will settle along the warp and weft of the rug and can be seen in the backing.

Cleaning a rug only requires a few basic tools. You may need:

Rug beater or broom
Rug shampoo or safe cleaning solution
Two 5 gallon buckets
Large sponges
Towels
Large tarp
Fan

Before cleaning a rug, read the care instructions on the rug’s label. Try to pick a time to clean your rugs when there is going to be three or four sunny, hot days together. It may be a lot easier to clean your rugs outdoors, and sun and warm atmosphere will help them dry more quickly and thoroughly. Plus, the sunlight is a natural and effective deodorizer and this will keep most of the dirt and dust from the home. Whether an outside area isn’t accessible, use any floor area which moisture will not damage (like concrete or vinyl floor in the kitchen or kitchen.)

Shake or conquer Take smaller rugs and medium-sized rugs outdoors and provide them a good shake to discharge loose dirt and dust. If the rug is large, ask a partner for help to hang the rug over a porch rail or above a couple of solid chairs. Do not forget to shake out the rug pad too.

Test the rug for colorfastness: Before cleaning a rug with any kind of solution, it needs to be examined for colorfastness to avoid harm. Dab the cleaning solution on a small corner of this rug with a white towel. Allow the test spot dry completely, then check again to make certain colours haven’t bled or faded.

Dip the sponge/brush to the cleaning solution. Don’t over-wet the fibers–just use as much as required. Work in a 3- from 3-foot location. Rinse the sponge/brush regularly so the dirt won’t be transferred.

Scrub the rug completely: It’s important not to leave any soap substance on the rug. Soap will attract more dirt. Dip a clean sponge at the rinse water and remove any soap in the area just cleaned.

Blot: Push out as much excess water as you can with a squeegee and moving from the direction of the rug nap. Utilize the towels to absorb any excess moisture. Scrub, rinse and blot a place before going into the next.

Dry: Hang up the rug to dry, or put the rug flat, face-up and prop the underside with risers to permit for air flow. Let the rug dry completely before bringing it back indoors, rotating it periodically to promote even drying. Once inside, turn on fans to encourage more air flow and assist the rug dry more completely.

Adjust rug fibers: Once the rug has dried thoroughly, lightly examine the rug using a vacuum or a soft-bristle brush to Blend the fibers.

Steam cleaners: If your rug is extremely soiled, it could be worth it to rent a commercial steam cleaner. Vacuum the rug first, then follow the company’s directions on the best way to run the machine.