Area rugs are a great way to add warmth and personality to your decoration, but after prolonged use, they will need a good cleaning to seem like brand new. For most contemporary rugs, cleaning can be a once-a-year DIY project that saves you the cost of professional cleaning. If your rug is tagged with particular cleaning instructions, follow these.
Generally, area rugs just have to be deep cleaned annually. Listed below are a few ways to determine If It’s time for Rug Cleaning in Channel Islands Beach:
1. Lift a corner of the rug and lightly kick the back. If the rug releases a large cloud of dust, it definitely needs some attention.
2. Run your hand against the rug face in a circular motion for 10 seconds, then look at your palm; if your hand is dirty, then so is the rug.
3. Check for signs of deeply embedded dirt by looking at the rug backing. Deep-down dirt will settle along the warp and weft of the rug and can be seen in the backing.
Cleaning a rug just requires a few basic tools. You will need:
Rug beater or broom
Rug shampoo or safe cleaning solution
Two 5 gallon buckets
Prior to cleaning a rug, read the care instructions on the rug’s tag. Try to pick a time to clean your rugs if there will be three or four glowing, hot days together. It may be a lot easier to clean your rugs outside, and sunshine and warm air will help them dry faster and thoroughly. Plus, the sun is a natural and effective deodorizer, which will keep most of the dust and dirt from the home. Whether an outdoor area isn’t available, use any floor area that moisture won’t damage (like concrete or vinyl floor in the kitchen or kitchen.)
Shake or conquer Require smaller rugs and medium-sized rugs outdoors and provide them a good shake to discharge loose dust and dirt. If the rug is large, request a spouse for help to hang the rug over a porch railing or above a couple of solid chairs. Use a broom or rug beater to hit on the rug all over to loosen deeply embedded dirt. Do not forget to shake out the rug pad too.
Mix the cleaner: Create a cleaning solution as directed by your preferred rug shampoo, or blend two to three teaspoons of mild dish soap to one of those 5-gallon buckets with warm water.
Test the rug for colorfastness: Prior to cleaning a rug with any kind of solution, it needs to be examined for colorfastness to prevent damage. Dab the cleaning solution on a tiny corner of the rug with a white towel. Allow the test place dry completely, then check again to make sure colours haven’t bled or faded.
Scrub, if needed: When the rug is colorfast, apply the soap solution to the rug using a soft-bristle brush or sponge. Start at one end of the rug. Dip the sponge/brush to the cleaning solution. Do not over-wet the fibers–just use as much as needed. Work in a 3- by 3-foot location. Rinse out the sponge/brush regularly so the dirt won’t be transferred.
Rinse the rug thoroughly: It’s important not to leave any soap substance on the rug. Dip a clean sponge at the rinse water and then remove any soap from the region just cleaned.
Blot: Drive as much excess water as possible with a squeegee and moving in the path of the rug nap. Scrub, rinse and blot a place before going into the next.
Dry: Hang up the rug to dry, or put the rug level, face-up and prop the underside with risers to allow for air flow. Allow the rug dry completely prior to bringing it back indoors, rotating it periodically to promote even drying. Once inside, turn on fans to encourage more air flow and assist the rug dry completely.
Adjust rug fibers: When the rug has dried completely, lightly go over the rug using a vacuum or a soft-bristle brush to Blend the fibers.
Steam cleaners: If your rug is extremely soiled, it could be well worth it to rent a commercial steam cleaner. Vacuum the rug first, then follow the manufacturer’s instructions on how best to run the machine.
Check related blogs about Rug Cleaning:
Should I Take My Rug To My Dry Cleaner in Channel Islands Beach
Why You Need To Buy A Rug in Channel Islands Beach