What Is The Best Way To Clean A Rug in Benicia

Area rugs are a excellent way to add warmth and character to your decoration, but after prolonged use, they will require a fantastic cleaning to look like new. For many contemporary rugs, cleaning may be a once-a-year DIY project which saves you the cost of professional cleaning. If your rug is labeled with specific cleaning instructions, follow these.

In general, area rugs only have to be deep cleaned annually. Here are a Couple of ways to determine If It’s time for Rug Cleaning in Benicia:

1. Lift a corner of the rug and lightly kick the back. If the rug releases a large cloud of dust, it definitely needs some attention.

2. Run your hand against the rug face in a circular motion for 10 seconds, then look at your palm; if your hand is dirty, then so is the rug.

3. Check for signs of deeply embedded dirt by looking at the rug backing. Deep-down dirt will settle along the warp and weft of the rug and can be seen in the backing.

Cleaning a rug only requires a couple of basic tools. You may need:

Rug beater or broom
Rug shampoo or safe cleaning solution
Two 5 gallon buckets
Large sponges
Towels
Large tarp
Fan

Before cleaning a rug, read the care instructions on the rug’s label. Try to select a time to clean your rugs when there is going to be a few glowing, hot days together. It may be easier to clean your rugs outside, and sun and warm air will help them dry faster and thoroughly. Additionally, the sun is a natural and effective deodorizer and this will keep most of the dirt and dust out of the house. If an outside area isn’t available, use any floor area that moisture will not damage (like vinyl or concrete flooring in the kitchen or garage.)

Shake or beat: Take smaller rugs and medium-sized rugs outdoors and provide them a good shake to discharge loose dust and dirt. If the rug is large, ask a spouse for help to hang the rug above a porch rail or above a couple of solid chairs. Use a broom or rug beater to reach the rug all over to loosen deeply embedded dirt. Don’t forget to shake out the rug mat also.

Examine the rug for colorfastness: Prior to cleaning a rug with any type of solution, it should be tested for colorfastness to prevent harm. Dab the cleaning solution on a small corner of the rug with a towel. Allow the test place dry completely, then check again to make sure colors have not bled or faded.

Scrub, if necessary: When the rug is colorfast, put on the soap solution to the rug using a soft-bristle brush or sponge. Dip the sponge/brush into the cleaning solution. Do not over-wet the fibers–only use as much as needed. Work in a 3- by 3-foot location. Rinse out the sponge/brush regularly so the dirt will not be transferred.

Scrub the rug completely: It is important not to leave any soap substance on the rug. Soap will attract more dirt. Dip a clean sponge at the rinse water and then remove any soap from the area just cleaned.

Blot: Push out as much excess water as possible using a squeegee and moving from the direction of this rug nap. Scrub, rinse and blot an area before moving into the next.

Dry: Hang up the rug to dry, or lay the rug flat, face-up and prop the underside with risers to allow for air circulation. Allow the rug dry completely prior to bringing it back indoors, rotating it occasionally to promote even drying. Once inside, turn on fans to encourage greater air flow and assist the rug dry completely.

Adjust rug fibers: Once the rug has dried completely, lightly go over the rug using a vacuum or a soft-bristle brush to Blend the fibers.

Steam cleaners: If your rug is very soiled, it could be well worth it to rent a commercial steam cleaner. Vacuum the rug first, then follow the company’s instructions on the best way to operate the machine.