Area rugs are a excellent way to add warmth and character to your decor, but after prolonged use, they will require a good cleaning to look like new. For many contemporary rugs, cleaning may be a once-a-year DIY project that saves you the cost of specialist cleaning. If your rug is tagged with specific cleaning instructions, follow those.

In general, area rugs only need to be deep cleaned annually. Listed below are a Couple of ways to determine If It’s time for Rug Cleaning in Belmont:

1. Lift a corner of the rug and lightly kick the back. If the rug releases a large cloud of dust, it definitely needs some attention.

2. Run your hand against the rug face in a circular motion for 10 seconds, then look at your palm; if your hand is dirty, then so is the rug.

3. Check for signs of deeply embedded dirt by looking at the rug backing. Deep-down dirt will settle along the warp and weft of the rug and can be seen in the backing.

Cleaning a rug just requires a couple of basic tools. You will need:

Rug beater or broom
Rug shampoo or safe cleaning solution
Two 5 gallon buckets
Large sponges
Towels
Large tarp
Fan

Try to select a time to clean your rugs when there is going to be three or four sunny, hot days together. It could be easier to clean your rugs outside, and sun and warm atmosphere will help them dry faster and thoroughly. Additionally, the sun is a natural and effective deodorizer and this will keep most of the dirt and dust out of the house. If an outdoor area isn’t accessible, use any floor area that moisture will not damage (like concrete or vinyl floor in the kitchen or kitchen.)

Shake or conquer Take smaller rugs and medium-sized rugs outdoors and provide them a fantastic shake to discharge loose dirt and dust. If the rug is large, ask a spouse for assistance to hang the rug above a porch rail or above a couple solid chairs. Use a broom or rug beater to hit the rug all over to loosen deeply embedded dirt. Do not forget to shake the rug pad too.

Mix the cleaner: Make a cleaning solution as instructed by your chosen rug shampoo, or mix two to three teaspoons of mild dish soap into among those 5-gallon buckets with warm water. Fill the other bucket with clean water.

Test the rug for colorfastness: Prior to cleaning a rug with any type of solution, it needs to be examined for colorfastness to avoid harm. Dab the cleaning solution on a tiny corner of the rug with a white towel. Let the test spot dry completely, then check again to make certain colors have not bled or faded.

Scrub, if necessary: If the rug is colorfast, apply the soap solution to the rug using a soft-bristle brush or sponge. Dip the sponge/brush to the cleaning solution. Don’t over-wet the fibers–just use as much as required. Work in a 3- from 3-foot area. Rinse the sponge/brush frequently so the dirt will not be transferred.

Scrub the rug completely: It is important not to leave any soap substance on the rug. Soap will attract more dirt. Dip a clean sponge in the rinse water and remove any soap in the area just cleaned.

Blot: Push out as much excess water as possible with a squeegee and moving from the path of this rug nap. Utilize the towels to absorb any excess moisture. Scrub, rinse and blot a place before moving into the next.

Dry: Hang up the rug to dry, or lay the rug level, face-up and prop the bottom with risers to allow for air flow. Allow the rug dry thoroughly prior to bringing it back inside, rotating it periodically to promote even drying. Once inside, turn on fans to promote greater air circulation and assist the rug dry completely.

Adjust rug fibers: Once the rug has dried completely, lightly go over the rug with a vacuum or a soft-bristle brush to refresh the fibers.

Steam cleaners: If your rug is very soiled, it could be worth it to rent a commercial steam cleaner. Vacuum the rug first, then follow the manufacturer’s instructions about the best way to run the machine.

Check related blogs about Rug Cleaning:
Make A Weekly Cleaning Schedule in Belmont
What On Earth Are Area Rugs Anyway in Belmont