Area rugs are a excellent way to add warmth and character to your decor, but after prolonged use, they will require a good cleaning to look like new. For most modern rugs, cleaning may be a once-a-year DIY project which saves you the expense of specialist cleaning. If your rug is labeled with specific cleaning instructions, follow those.

In general, area rugs just need to be deep cleaned yearly. Listed below are a Couple of ways to determine If It’s time for Rug Cleaning in Bell Gardens:

1. Lift a corner of the rug and lightly kick the back. If the rug releases a large cloud of dust, it definitely needs some attention.

2. Run your hand against the rug face in a circular motion for 10 seconds, then look at your palm; if your hand is dirty, then so is the rug.

3. Check for signs of deeply embedded dirt by looking at the rug backing. Deep-down dirt will settle along the warp and weft of the rug and can be seen in the backing.

Cleaning a rug just requires a couple of basic tools. You will need:

Rug beater or broom
Rug shampoo or safe cleaning solution
Two 5 gallon buckets
Large sponges
Towels
Large tarp
Fan

Try to select a time to clean your rugs when there will be three or four glowing, hot days together. It may be a lot easier to clean your rugs outdoors, and sun and warm atmosphere will help them dry faster and thoroughly. Additionally, the sun is a natural and effective deodorizer, which will keep the majority of the dirt and dust out of the home. If an outdoor area isn’t accessible, use any floor area that moisture will not damage (like vinyl or concrete flooring in the kitchen or garage.)

Shake or beat: Take smaller rugs and darkened rugs outdoors and give them a good shake to discharge loose dirt and dust. If the rug is large, ask a partner for assistance to hang the rug over a porch rail or above a couple solid chairs. Use a broom or rug beater to reach on the rug around to loosen deeply embedded dirt. Do not forget to shake out the rug pad too.

Mix the cleaner: Create a cleaning solution as instructed by your chosen rug shampoo, or blend two to three teaspoons of mild dish soap to one of those 5-gallon buckets with warm water. Fill another bucket with clean water.

Test the rug for colorfastness: Before cleaning a rug with any kind of solution, it should be examined for colorfastness to avoid harm. Dab the cleaning solution on a tiny corner of this rug with a towel. Check to find out whether any color transfers to the towel. Let the test spot dry thoroughly, then check again to make certain colours haven’t bled or faded.

Start at one end of the rug. Dip the sponge/brush to the cleaning solution. Don’t over-wet the fibers–just use as much as required. Function in a 3- by 3-foot area. Rinse the sponge/brush regularly so the dirt won’t be transferred.

Scrub the rug thoroughly: It is important not to leave any soap material on the rug. Soap will attract more dirt. Dip a clean sponge in the rinse water and then remove any soap from the area just cleaned.

Blot: Push out as much excess water as possible using a squeegee and moving in the direction of this rug nap. Scrub, rinse and blot an area before going to the next.

Dry: Hang up the rug to dry, or put the rug flat, face-up and prop the underside with risers to allow for air circulation. Let the rug dry completely prior to bringing it back inside, rotating it occasionally to promote even drying. Once inside, turn on fans to encourage greater air flow and help the rug dry completely.

Adjust rug fibers: When the rug has dried thoroughly, lightly examine the rug with a vacuum or a soft-bristle brush to refresh the fibers.

Steam cleaners: If your rug is very soiled, it could be worth it to rent a commercial steam cleaner. Vacuum the rug first, then follow the company’s directions on how best to run the machine.

Check related blogs about Rug Cleaning:
How to Clean Wool Area Rugs in Bell Gardens
Why You Need To Buy A Rug in Bell Gardens