How to Clean a Rug
Rug Cleaning in Winnetka — Rather than spending a fortune becoming your area rug professionally cleaned, follow these cleaning tips from DIY experts.Area rugs are a gorgeous way to pull a room together. They add colour and warmth, and feel good under bare feet. To earn a rug endure for years, you have to clean and maintain it. When it’s time to deep clean it is possible to roll it up and send it out to a professional, or you could do it yourself and save a ton of money. Here is the way to clean a rug and eliminate stains without having to spend a lot of money.
First, vacuum the rug on front and back to remove surface dirt and debris. Use the brush attachment to remove pet hair. Just take the rug out and lay flat on a waterproof surface. A patio or driveway is ideal.
If you are using a store-bought rug shampoo, follow the directions on mixing and on the way to clean a rug. It is also possible to make your own cleaner by mixing a couple squirts of liquid dish soap into a bucket of warm water. Don’t use hot water as it could shrink and fade the rug. Test the solution at a small, inconspicuous area of the rug to make sure it’s colorfast. If the colours do not run, you’re prepared to go.
With a sponge or a soft-bristled cleaning brush, then apply the cleaning solution to the rug and work it into a lather. Don’t oversaturate the rug. Allow the cleaner to sit on the rug for 5 minutes. Use your garden hose to wash the rug off. Utilize a wet/dry vacuum to eliminate as much water as possible from the rug. Leave the rug outdoors until it is completely dry before returning the clean area rug to its place in the house.You may want to turn it over and make it possible for the rug to wash one side at one time.
Take it to a professional. Persian rugs are expensive and you do not wish to ruin one with a DIY cleaning occupation. Spot-clean them only.
To remove stains out of the rug, mix 1 tsp liquid dish soap, 1 spoonful of warm water along with 1 teaspoon of vinegar. Use a soft cloth to apply cleaner into the stain and blot gently. Do not rub because you are able to cause the carpet fibers . Let the solution remain on the spot for a minimum of five minutes. Use a clean cloth dipped in water to rinse the soap out. Blot with a dry towel . For stubborn stains or to remove mold and mildew, spot clean with a mix that’s one part hydrogen peroxide into five parts .
Check related blogs about Rug Cleaning:
How Much Does It Cost To Dry Clean A Rug in Winnetka
What Is The Best Way To Clean A Rug in Winnetka