How Are Rugs Cleaned?

Could your area rugs use a deep clean? Discover how to clean a rug yourself and you’re able to bring all of your flooring coverings back to life whenever you prefer. After a time, vacuuming only is not enough to receive it truly clean–and that’s when knowing the way to do it yourself comes in super easy.

Area Rug Cleaning in Sylmar is a project you can readily take on yourself.

Note: There’s no requirement to clean rugs on a schedule. Read on to learn how to refresh those well-worn area rugs so they look as good as they did when you unrolled them.

1. Gather Your Tools and Supplies

Here is what you’ll need to have on hand to complete a successful area Rug Cleaning in Sylmar:

Rug shampoo (or mild dish soap)

Bucket
Soft-bristle brush or sponge
Water
Optional:
Rubber gloves
Garden hose
Wet-dry vacuum

2. Eliminate Dirt and Debris
Gently vacuum about the rug on either side. You should be certain every last bit of debris has been gone.

3. Mix Your Cleaner
When it comes to the actual cleaning solution, you can use a rug shampoo. Whatever shampoo you opt for follow its specific instructions (located on the bottle) for mixing.

Alternatively, you may even use gentle dish soap mixed in a bucket with warm water. Do not use hot water as it could shrink the rug or cause fading.

4. Do a Color Test
Before you start scrubbing, be sure the cleaner does not cause the colors to run. Test the alternative to the corner of the rug to be certain it’s colorfast. If the color does not bleed, it’s safe to move on to another step.

5. Wash the Rug
With a sponge or soft-bristle brush, work the cleaning solution into a lather on the rug. Allow the cleaner sit on the rug for a five minutes before you start rinsing. Anything less than that and you’re going to shortchange the cleaning procedure. Give it those five minutes to set in and get started lifting dirt away.

6. Rinse the Rug
Scrub the soap out of the rug using a garden hose or buckets of clean water. Make certain all of the cleaning solution is totally taken out of the area rug along with the runoff water is crystal clear.

7. Remove Excess Water
At this point, you are going to want to do away with as much excess water from the rug because possible so it’ll dry faster.

8. Permit the Rug Dry
Lay the rug level and permit the cover of the rug to dry thoroughly. After that, turn it over to allow the base side dry. Fans may help speed up the procedure. Make sure the rug is fully dry before you return it to the area.

9.
During the cleaning process, threads and fibers may get compacted and compacted. Revive them by conducting a vacuum over the now-dry rug, or brush with a foul-smelling brush. Now you are finished, and may enjoy your freshly cleaned carpet. You know how to clean an area rug yourself, and you can complete the job whenever you like.

Check related blogs about Rug Cleaning:
How Much Does It Cost To Dry Clean A Rug in Sylmar