Could your area rugs use a deep clean? Learn how to clean a rug yourself and you can bring all your floor coverings back to life whenever you prefer. Area rugs may bring a room together, but they also requires a beating, in the foot traffic to spills and pets. After a time, vacuuming just isn’t enough to get it truly clean–and that is when knowing the way to do it yourself comes in super easy.

Area Rug Cleaning in San Carlos is a job you can easily take on your own.

Notice: There’s no need to clean rugs on a program. Keep reading to learn how to refresh those well-worn area rugs so that they look as good as they did when you unrolled them.

1.

Bucket
Soft-bristle sponge or brush
Water
Optional:
Rubber gloves
Garden hose
Wet-dry vacuum

2. Remove Dirt and Debris
Gently vacuum on the rug on both sides. You should be certain every last piece of debris has been gone. For those who have pets, then use the brush attachment to get any lingering stray hairs.

3. Mix Your Cleaner
If it comes to the real cleaning solution, you may use a rug shampoo. Whatever shampoo you choose, follow its precise directions (located on the bottle) for mixing.

Alternatively, you can even use gentle dish soap mixed in a bucket with warm water.

4. Do a Colour Test
Before you start scrubbing, make sure the cleaner does not cause the colors to run. Test the alternative on the corner of the rug to make sure it is colorfast. If the color doesn’t bleed, it is safe to proceed to the next step.

5. Wash the Rug
Using a sponge or soft-bristle brush, work the cleaning solution into a lather on the rug. Allow the cleaner sit on the rug to get a five minutes before you start rinsing. Anything less than that and you’re going to shortchange the cleaning process. Give it those five minutes to install and start lifting away dirt.

6. Rinse the Rug
Rinse the soap from this rug using a garden hose or buckets of clean water. Be certain all the cleaning solution is totally taken out of the area rug and the runoff water is crystal clear.

7. Remove Extra Water
Now, you’ll want to get rid of as much surplus water in the rug because you can so it will dry faster. You can use a wet-dry vacuum if you have one, or use a squeegee at the direction of the nap.

8. Permit the Rug Dry
The next-to-last measure to clean an area rug is just letting it dry. Lay the rug flat and allow the top of the rug to dry thoroughly. After that, flip it over to allow the base side dry. Fans may help hasten the process. Make sure the rug is fully dry before you return it to the room.

9. Vacuum or Brush Out the Rug
During the cleaning process, threads and fibers can get compacted and squished. Revive them by running a vacuum within the now-dry rug, or brush them with a soft-bristled brush. Now you’re finished, and can enjoy your freshly cleaned carpet. You know how to clean an area rug your self, and you can finish the job whenever you prefer.

Check related blogs about Rug Cleaning:
Area Rugs in San Carlos
How Much Does It Cost To Dry Clean A Rug in San Carlos