Can your area rugs utilize a clean? Learn how to clean a rug and you’re able to bring all of your floor coverings back to life whenever you like. Area rugs may bring a room together, but they also takes a beating, from foot traffic to pets and spills. After a while, vacuuming just is not sufficient to receive it really clean–and that’s when knowing how to do it yourself comes in super handy.

Area Rug Cleaning in Half Moon Bay is a job you can readily take on yourself.

Notice: There’s no requirement to clean rugs on a schedule. Read on to learn how to Combine those well-worn area rugs so that they look as great as they did when you first unrolled them.

1. Collect Your Tools and Supplies

Bucket
Soft-bristle brush or sponge
Water
Optional:
Rubber gloves
Garden hose
Wet-dry vacuum

2. Remove Dirt and Debris
Thoroughly vacuum on the rug on both sides. You want to be certain every last bit of debris has been gone.

3. Mix Your Cleaner
If it comes to the actual cleaning solution, you can use a rug shampoo. Whatever shampoo you opt for follow its specific instructions (found on the bottle) for blending.

Alternatively, you may also use mild dish soap mixed in a bucket with warm water.

4. Do a Colour Test
Before you start scrubbing, make sure that the cleaner doesn’t cause the colors to run. Examine the solution on the corner of the rug to be certain it is colorfast. If the color doesn’t bleed, it’s safe to move on to the next step.

5. Wash the Rug
Allow the cleaner sit on the rug to get a couple of minutes before you start rinsing. Anything less than that and you’re going to shortchange the cleaning procedure. Give it those five minutes to set in and get started lifting dirt away.

6. Rinse the Rug
Be sure all of the cleaning solution is totally taken out of the area rug and the runoff water is crystal clear.

7. Remove Excess Water
At this point, you are going to want to get rid of as much surplus water from the rug because possible so it will dry quicker. You can use a wet-dry vacuum should you have one, or use a squeegee in the direction of the nap.

8. Let the Rug Dry
Lay the rug flat and permit the top of the rug to dry thoroughly. Then, flip it over to let the base side dry. Fans may help hasten the procedure. Be certain that the rug is totally dry before you return into the area.

9. Vacuum or Brush Out the Rug
During the cleaning process, fibers and threads can get compacted and compacted. Revive them by conducting a vacuum over the now-dry rug, or brush them with a soft-bristled brush. Now you are finished, and may enjoy your newly cleaned carpet. You understand how to clean an area rug yourself, and you can finish the job when you prefer.

Check related blogs about Rug Cleaning:
How to Clean a Rug in Half Moon Bay